Product Details
The connectors on the Flow Switch are attached to a pc board connector that is located on the PC Board (usually at the top). There are other wires connected to this plug: Jumper interlock wire,Flow Switch, High Limit and Temp sensor. Remove the pin connector from the board . To remove a sensor or switch wire from the sensor harness connector, insert a paper clip into the slot corresponding with the wire to be removed. This will depress the pin tine, allowing the wire to be pulled from the harness connector. Important! When reinstalling the sensor or switch wire back into the sensor harness connector, make sure the pin tine is lifted (approx. 1/32" prior to inserting the wire. This will insure the sensor wire locks into the harness connector. Do not over bend the pin tine or it may break off.
Spa covers, filter cartridges that are used or have been wet, spa equipment packs, heaters and any electrical items (including but not limited to: circuit boards, spa control panels, contactors, switches, sensors, speakers, transformers, pumps and motors) are a FINAL SALE. Manufacturer's warranty still applies and can be returned for warranty only. Maximum manufacturer's warranty on electronics is 6 months.
